Page 1 of 1

besoin de renseignement mécanique

Posted: January 5, 2009, 10:40 am
by jasmin75
bonjours, j'aimerais savoir une chose, j'ai un trv 700 2008 et j'ai démanché le cardan arriere pour x raison, j'aimerais savoir à combien de lbs de torque il faut serrer la grosse nut au bout du cardan (coté roue genre 1¼'' de diametre) celle avec la cutter pin ????

Re: besoin de renseignement mécanique

Posted: January 5, 2009, 11:28 am
by gab81
Selon le Repair Manual, ils disent 200 livres pieds!!!
INSTALLING REAR DRIVE AXLE
1. Slide the drive axle into place in the gear case.
NOTE: To assure proper seating of the axle, give
it a light pull; the axle should remain “clipped” in
place.
2. Swing the knuckle up and onto the drive axle; then
place the knuckle into place in the upper A-arm.
Secure the knuckle to the A-arm with a cap screw
and a new lock nut. Tighten to 35 ft-lb.
3. Place the hub into position on the axle followed by
a hex nut. Tighten the hex nut finger-tight at this
time.
4. If the brake calipers were removed, position them
on the knuckle and secure with existing cap
screws. Tighten the auxiliary brake caliper cap
screws to 20 ft-lb. Tighten the hydraulic brake caliper
cap screws to 20 ft-lb.
5. Pump up the hand brake lever; then engage the
brake lever lock.
6. Tighten the hub hex nut (from step 3) to 200 ft-lb;
then install and spread a new cotter pin making
sure each side of the pin is flush to the hub nut.
7. Install the wheel. Tighten to 40 ft-lb.

Re: besoin de renseignement mécanique

Posted: January 5, 2009, 12:44 pm
by jasmin75
merci , cé en plein les infos que je voulais savoir