besoin de renseignement mécanique

Tout sur les Arctic Cat
Post Reply
jasmin75
Posts: 23
Joined: March 20, 2006, 6:52 pm
VTT: kfx
Location: terrebonne

besoin de renseignement mécanique

Post by jasmin75 »

bonjours, j'aimerais savoir une chose, j'ai un trv 700 2008 et j'ai démanché le cardan arriere pour x raison, j'aimerais savoir à combien de lbs de torque il faut serrer la grosse nut au bout du cardan (coté roue genre 1¼'' de diametre) celle avec la cutter pin ????


gab81
Posts: 209
Joined: June 16, 2008, 1:20 pm
VTT: TRV 700 Cruiser
Location: Sherbrooke

Re: besoin de renseignement mécanique

Post by gab81 »

Selon le Repair Manual, ils disent 200 livres pieds!!!
INSTALLING REAR DRIVE AXLE
1. Slide the drive axle into place in the gear case.
NOTE: To assure proper seating of the axle, give
it a light pull; the axle should remain “clipped” in
place.
2. Swing the knuckle up and onto the drive axle; then
place the knuckle into place in the upper A-arm.
Secure the knuckle to the A-arm with a cap screw
and a new lock nut. Tighten to 35 ft-lb.
3. Place the hub into position on the axle followed by
a hex nut. Tighten the hex nut finger-tight at this
time.
4. If the brake calipers were removed, position them
on the knuckle and secure with existing cap
screws. Tighten the auxiliary brake caliper cap
screws to 20 ft-lb. Tighten the hydraulic brake caliper
cap screws to 20 ft-lb.
5. Pump up the hand brake lever; then engage the
brake lever lock.
6. Tighten the hub hex nut (from step 3) to 200 ft-lb;
then install and spread a new cotter pin making
sure each side of the pin is flush to the hub nut.
7. Install the wheel. Tighten to 40 ft-lb.
Anciennement : Honda TRX450ES 2000 Très bien Équipé.... BRULER
Maintenant : A-C TRV700EFI Cruiser 2008 Qui sera lui aussi bien Équipé!!!
Image
jasmin75
Posts: 23
Joined: March 20, 2006, 6:52 pm
VTT: kfx
Location: terrebonne

Re: besoin de renseignement mécanique

Post by jasmin75 »

merci , cé en plein les infos que je voulais savoir
Post Reply

Return to “Arctic Cat”