Page 1 of 1

Signification !

Posted: July 19, 2006, 2:14 pm
by Marc Mad
Que veulent exactement dire les termes suivants :

-S.W. (in.)
-O.D. (in.)

Merci !

Posted: July 19, 2006, 3:04 pm
by Steph
2. Definitions
2.1 Tire Size
The size of each tire is indicated by nominal width and
rim diameter in inches and mm.
Radial structure is indicated by the letter “R”. For some
tire the aspect ratio is indicated by percentage.
Example
Radial Tire ; 40.00R57, 33.25R35, 445/95R25
Bias Tire ; 30.00-51, 45/65-45
2.2 Star Rating, Ply Rating and
Load Index
The load capacity of a tire is indicated by the star
rating (in case of radial tire) and the ply rating (in case
of bias tire).
The load index is applied in countries where the
ETRTO standards are used.
2.3 Overall Diameter (OD)
“Overall Diameter” is twice the section height of a new
tire, plus the nominal rim diameter, including 24-hour
inflation growth.
2.4 Overall Width (OW)
“Overall Width” is the width of a new tire, including 24-
hour inflation growth, and including protective side ribs,
bars or decorations.
2.5 Section Width (SW)
“Section Width” is the width of a new tire, including 24-
hour inflation growth and including normal sidewalls, but
not including protective side ribs, bars, or decorations.
2.6 Static Loaded Radius and
Width (SLR, SLW)
“Static Loaded Radius” is the shortest distance from the
axle center to the contact surface of a tire and “Static
Loaded Width” is the overall width of a tire, mounted on
the approved rim at the specified inflation pressure and
placed still and vertically on a flat board, and loaded with
the specified load.
2.7 Original Tread Depth (OTD)
“Original Tread Depth” is the tread depth of a new tire
measured at the point of tread-indicator where available
or one-fourth the width of the tire crown section from the
crown center, including 24-hour inflation growth.

Posted: July 19, 2006, 4:28 pm
by Marc Mad
Et en francais maintenant :P

Non blague !

Si jai bien compris

S.W = C'est la largeur une fois monter et gonfler

O.W = meme chose Maintenant on parle de la hauteur

Jme trompe !

Merci !