Page 7 of 8
Posted: January 22, 2008, 6:34 pm
by Zzzzz
Checker ca,
http://www.northeastmoto.com/forums/arc ... -4413.html
Un renegade a 62 hp au moteur. Sur nos zezette, on a 50 au roue.
Pas vraiment de question à poser. :?
Posted: January 23, 2008, 7:06 pm
by Lebleu
Zzzzz wrote:..........Un renegade a 62 hp au moteur. Sur nos zezette, on a 50 au roue.
Pas vraiment de question à poser. :?
Un Renegade a environ 70 aux roues.
Posted: January 23, 2008, 7:20 pm
by cat 800

un out 800 a 39 stock.
Posted: January 23, 2008, 7:21 pm
by DkoD
mes soulier en ont aucun
Posted: January 23, 2008, 7:26 pm
by gad
mon char a 134 au roue

Posted: January 23, 2008, 8:08 pm
by yangee
gad wrote:mon char a 134 au roue

pis le mien plus que 400 :wink:
Posted: January 24, 2008, 4:22 pm
by Zzzzz
Allez voir le line que j'ai mis, c'est un test au dyno
Posted: January 25, 2008, 9:19 am
by yangee
Zzzzz wrote:Allez voir le line que j'ai mis, c'est un test au dyno
tien moi aussi j'En ai un de mon STI..
http://videos.qsrproductions.com/search ... 349cab.htm
Posted: January 25, 2008, 6:51 pm
by Lebleu
cat 800 wrote:

un out 800 a 39 stock.
Tu dis qu'un Out 800 a 39 stock, alors un Renegade aurait 40.5 car il a le même moteur, les mêmes différentiels et des pneus 4% plus petit, donc 4% plus de HP au roues que le Out; 39 X 104% = 40.5.
Ça fait qu'un Renegade qui a 40.5 HP au roues qui pèse 607 lbs accote et même mange un sport stock qui a 50 HP au roues et qui pèse 425 lbs.
Alors explique moi ça mon Cat800. :-D
Posted: January 25, 2008, 8:19 pm
by cat 800
je me suis un peu trompé,il a 39 au roue avec les pneus d'origine,avec les pneus de dyno ont va dire,il monte a 44hp a cause qu'il ne vire pas dessour sur le dyno avec sa.
Ok here is the Update on the pipe. and dyno testing from today.
The actual numbers don't tell the whole story, since I was forced to use stock knobby tires today. The few times I have had to do that with other machines, it has always caused the numbers to drop, do to slippage on the dyno's drum. Example my Outy was around 39hp with knobby's. With my dyno tires it the all the Outys tested in the 44hp range. I know from real wold experience that these machines are not separated by only 2 hp. I have seen it on grass and sand. Those real world test were with a piped Outy making 49hp with dyno tires. So If I were t estimate what it would have shown with slicks today after the pipe was added, I would have to say add 5-7 hp to the numbers I actually got using the knobby tires.
sa c'Est pour le thunder cat avec pneus d'origine
Test one 100% bone stock came out 46hp 37lbs of torque
Test 2 was just pulling the spark arrestor cap out the back of the OEM muffler, that time I got 49hp and 38lbs of torque
Test 3 was with the new Black magic pipe, It made 51hp and 40lbs of torque
Picked up right at about 5 hp and 3 lbs pf torque. AFRs were from 13.4right on bottom around 15mph to high 12s-13 even the rest of the way to the Rev limiters.
Another note, the Rev limiters starts kicking in around 77-78mph. If you run up on it you can pass it for a split second and hit 80mph. If memory serves me right Thia's about 3-4 mph higher than I can get to with my can-am on the dyno. If understand the design of the CVT drives, that means real world this machine should top out mid to high 70s where the Outy is low to mid 70s.
That is pretty much what I was expecting to happen today.
Everyone keep in mind that what I am sharing here is more about the gains not the actual numbers, you will likely see all sorts of different results from several different people as far as actual peak numbers. So the real story here is what gains you can get with a pipe, or with just removing the cap off the back of the stocker made some nice power.
Posted: January 25, 2008, 9:14 pm
by Lebleu
Un Out 800 a 62 HP au moteur.
Est-ce à la sorti du drive-shaft ou à la poulie meneuse du morteur (clutch)?????????
Posted: February 24, 2008, 9:34 pm
by Risk
excuse moi mais je ne sais pas ou vous prenez vos force au roue je passe mon temps sur le dyno pis les seul que je vois passer le 50force au roue
les vtt val au moin 20mille$$ ceux qui se monte le plus ces yam benshee
mais sa toff pas si vous avez des vtt de 60force au roue je veux les voir sur le dyno je le pay pis si ya pas 60hp vous le payer fait attention autest sur internet on peu fair ecrire ce que lon veut sur un dyno jai 40ride sur le dyno
jai 41force kfx 700 je suis pres a fair du drag avec ninporte quoi pis meme si vous avez 60hp vous avez besoin detre driver en titi pour le tenir a terre
en passent je ne suis pas un jeuno jai 40ans ces pour sa que jai un kfx700 haha automatique hi hi hi
Posted: February 24, 2008, 9:46 pm
by SHEE RIDER
http://www.lespac.com/search/detail.php ... e=0&etat=0 tenez si vs voulez de quoi qui marche le gars reste proche de chez nous
Posted: February 24, 2008, 9:47 pm
by mrpout
Le hp qu'ils parlent, c'est au crank selon moi...comme les chars quoi... :wink:
Moi j'ai 46...pas au roues...mais au crank...la poulie enlevé...selon le carb américain en tout cas... :wink:
Pout
Posted: February 24, 2008, 9:57 pm
by gad
8500$ st'un malade....