je retiens sa,le niveau doit etre entre le maximum et le minimum.Grizz007 a écrit :EBS00064gas a écrit :Ma pensée est enfin éclaircie...Maintenant c'est très clair ..
Merci beaucoup ...
Gas
CHECKING THE ENGINE OIL LEVEL
1. Place the vehicle on a level surface.
2. Check the engine oil level on a cold engine.NOTE:
_
If the engine was started before checking the
oil level, be sure to warm up the engine sufficiently,
and then wait at least 10 minutes until
the oil settles for an accurate reading.
3. Remove:
• dipstick accessing panel
Refer to “SEAT AND SIDE PANELS”.
4. Check:
• engine oil level
Oil level should be between the minimum
level mark a and maximum level mark b.
Oil level low → Add oil to the proper level.
NOTE:
To obtain an accurate oil level reading, the dipstick
must be inserted completely into the oil
filter hole.
CAUTION:
Do not allow foreign material to enter the
crankcase.
5. Check the engine oil level again.
CAUTION:
Be sure the engine oil is at the correct
level, otherwise engine damage may result.
Recommended engine oil type
YAMALUBE 4, SAE5W30,
SAE10W30 or SAE20W40
Recommended engine oil grade
API service SG type or higher,
JASO standard ¨¨¨CA C'EST LE MANUEL SHOP DU GRIZZLY 700, vérifie seulement ton huile à froid.....pis tout vas être correct.....
lire un manuel c'Est pratique,merci mr.bond grizz007